Free 830-01 Exam Braindumps
RCPE Certified Professional WAN Optimization Questions 166–170 (page: 35)

Updated On: 9-Feb-2026

Refer to the exhibit.


You configured CIFS prepopulation at Corp-A but it is not working. What is likely the cause of the issue?

  1. CIFS prepopulation requires WCCP
  2. Primary interface needs to be on a different subnet
  3. CIFS prepopulation requires a fixed-target rule
  4. The Primary interface needs to be on the LAN side of the Steelhead appliance
  5. CIFS prepopulation requires SMBv2

Answer(s): D



You have an in-house HTTP application running on port 8443 but you are not seeing HTTP optimization. You checked and made sure that the HTTP blade is enabled. What is the likely problem?

  1. Primary port needs to be on the LAN side of the Steelhead
  2. There is a separate license key for the HTTP blade
  3. The HTTP blade will only work on port 80 and 8080 and can not be changed
  4. The HTTP blade only supports HTTP 1.1 and the application is using HTTP 1.0
  5. HTTP blade is enabled by default on port 80 and 8080. An in-path rule is necessary for all other ports.

Answer(s): E



Refer to the exhibit.


Traffic going from Corp-A-DC-2 towards Corp-B will always use Link-1. Traffic from Corp-B back to Corp-A-DC-1 may traverse Corp-A-DC-1, over the GigaMAN before it reaches Corp-A-DC-2. No TCP connections are initiated from Corp-B to either Corp-A-DC-1 or Corp-A-DC-2. Unfortunately, the customer does not have any money to purchase any additional Steelheads. What are some possible fixes to ensure optimization occurs while Link-1 is operational? (If Link-1 ceases to function, optimization is not possible.) (Select 2)

  1. Configure a fixed-target rule on the Corp-A-DC-2 Steelhead pointing to the Corp-B Steelhead on port 7800
  2. On the Corp-B Steelhead, enable “in-path probe direct”
  3. On the Corp-A-DC-2 Steelhead, enable “in-path probe direct”
  4. Configure the Corp-A-DC-2 Steelhead to inject a route into the network
  5. Enable Full Transparency

Answer(s): A,C



Which of the following is NOT supported in Alarm Settings?

  1. Raise alarm when network interface duplex errors are detected
  2. Raise alarm when network interface link errors are detected
  3. Raise alarm when the number of optimized connections exceeds user specified limit
  4. Raise alarm if a software version mismatch is detected in the network
  5. Raise alarm when asymmetric routes are detected

Answer(s): C



The alerting threshold for CPU utilization is 70% and the reset threshold is 50%. Which of the following situations will result in an alarm being triggered? (Select 2)

  1. Initial utilization of 30% becomes 75%
  2. Drop from 90% of utilization to 70%
  3. Initial utilization of 73% becomes 90%
  4. Drop from 75% of utilization to 48% and shot up to 68%
  5. Drop from 75% of utilization to 48% and shot up to 78%

Answer(s): A,E



Viewing page 35 of 82
Viewing questions 171 - 175 out of 402 questions


Post your Comments and Discuss Riverbed 830-01 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!