Free 830-01 Exam Braindumps
RCPE Certified Professional WAN Optimization Questions 186–190 (page: 39)

Updated On: 9-Feb-2026

When troubleshooting a datastore wrapping alarm with 1 day wrapping notification configured, which of the following should be examined? (Select 2)

  1. If the unit was mis-sized
  2. If stream based encrypted traffic is being sent across the link as optimized
  3. If your fixed-target rules are pointing to the correct Steelhead appliance
  4. If Connection Forwarding was properly configured

Answer(s): A,B



What should you do when you receive the following message?

  1. Nothing. This is a warning message which means that the Steelhead appliance is resetting an internal state regarding this connection and it should not affect user performance.
  2. Switch off the Steelhead appliance
  3. Create a specific pass-through rule to bypass the above source and destination hosts
  4. Reload the Steelhead appliance

Answer(s): A



What should you do when you receive the following message? [intercept.NOTICE] sending kickoff RST: 10.35.178.41:1169 -> 10.110.141.30:1031.

  1. Nothing. This is just a notice message.
  2. Verify whether the "Reset Existing Client Connections on Start Up" option is checked and uncheck it
  3. Switch off the Steelhead appliance
  4. Create a specific pass-through rule to bypass the above source and destination hosts
  5. Restart the Steelhead appliance

Answer(s): B



Refer to the exhibit.


In the accompanying exhibit, SH3 and SH4 are able to optimize FTP and HTTP sessions between Client41 and the respective application hosts Server31 and Server32. However, optimization does not happen for Client42 and these application hosts. A quick check on SH3 and SH4 registers neither optimized nor pass-through traffic from Client42. Client42 is able to ping Client41 and the in-path address of SH4. Note that SH3 and SH4 are in auto-discovery mode. What is the likely cause?

  1. The default gateway of Client41 is configured wrong
  2. The default gateway of Client42 is configured wrong
  3. The default gateway of SH3 is configured wrong
  4. The default gateway of SH4 is configured wrong
  5. The routing protocol between R3 and R4 is configured wrong

Answer(s): B



Refer to the exhibit.


SH3 and SH4 are able to optimize FTP and HTTP sessions between Client41 and the respective application hosts Server31 and Server32. However, optimization seems to be a problem for Client42 and these application hosts. A quick check on SH3 and SH4 registers neither optimized nor pass- through traffic from Client42. Client42 is able to ping to both Server31 and Server32. Note that SH3 and SH4 are in auto-discovery mode. What is the likely cause?

  1. The default gateway of Client41 is configured wrong
  2. The default gateway of Client42 is configured wrong
  3. An outbound access-list specified at R3f0 denies TCP traffic from Client42
  4. The routing protocol between R3 and R4 is configured wrong

Answer(s): C



Viewing page 39 of 82
Viewing questions 191 - 195 out of 402 questions


Post your Comments and Discuss Riverbed 830-01 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!