Free S10-300 Exam Braindumps
SNIA Architect - Assessment, Planning & Design Questions 21–25 (page: 6)

Updated On: 26-Feb-2026

A customer is using host based virtualization to mirror critical data between two vendors disk arrays. Which two scenarios are true? (Choose two)

  1. The host can use the same HBA to connect to both arrays
  2. The customer can adhere to either vendors SAN design rules
  3. The customer must adhere to both vendors SAN design rules
  4. The host must use different HBAs with different firmware to connect to each array

Answer(s): C,D



An existing SAN has been experiencing numerous faults in the past few months, you have been tasked with bringing the problems to solution and ensure reliability. Your primary concern is visibility into the SAN and the present lack of monitoring. Which two are true about the existing infrastructure? (Choose two.)

  1. Evaluating vendor supplied tools, and knowledge base type documents may outline best practices for increasing reliability and reporting.
  2. Requesting vendor assistance, and if need be custom builds of the firmware/software that runs your array to fix the specific problems that you encounter.
  3. Testing and then Level settings firmware and code levels to a common vendor supported standard will allow you to avoid many of the problems that may have been encountered in the past.
  4. Since SMI-S is an emerging standard, the likelihood of being able to manage equipment bought in previous years is very low. A migration plan should be considered to an SMI-S compliant infrastructure.

Answer(s): A,C



A customer has created a disaster recovery (DR) plan and is synchronously replicating its data to a remote facility. The remote storage/server needs to be configured (LUN masking, zoning, and rescanning the SCSI bus). To failover the application, what must the customer do?

  1. failover storage, re-configure the remote storage/server, start application
  2. failover storage, start application, re-configure the remote storage/server
  3. pre-configure the remote storage/server, failover storage, start application
  4. pre-configure the remote storage/server, start application, failover storage

Answer(s): C



You are tasked with connecting a new pair of hosts to an existing SAN infrastructure. The existing infrastructure is a 2Gb/s Fibre Channel solution on the far side of your facility. What are three concerns for the new infrastructure? (Choose three.)

  1. The measured bit error rate (BER) is between "1 in 10^16" and "1 in 10^15"
  2. Cable lengths as long as you measure and insure a proper strength signal as measured in D
  3. Patch panels utilizing 50 micron optical cable for the long floor runs and 62.5 micron optical cable for the shorter patch panel to the server.
  4. Re-use of existing Gigabit Ethernet cable infrastructure since Gigabit Ethernet cables have the same specifications and limitations as Fibre Channel.

Answer(s): B,C,D



A network backup server is attached to a SAN. The server's two HBAs deliver 60 MB/s each to the tape devices. The tape library attached to the SAN includes 15 MB/s tape devices. Theoretically, how many tape devices are required to efficiently stream output from the tape server?

  1. 4
  2. 8
  3. 12
  4. 15

Answer(s): B



Viewing page 6 of 21
Viewing questions 26 - 30 out of 100 questions


Post your Comments and Discuss SNIA S10-300 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!