A clutch release bearing ________________.
Answer(s): C
When a clutch pedal is depressed, the release bearing comes in contact with the fingers of the clutch pressure plate and rotates.
The general procedure to follow when adjusting a band on an automatic transmission is to _______________.
Answer(s): A
To properly adjust an automatic transmission band, loosen the adjusting screw locknut. Then tighten the adjusting screw to the specified torque with a torque wrench. Next, loosen the adjusting screw the specified number of turns. Complete the job by holding the adjusting screw and tightening the locknut.
The purpose of the drive shaft is to connect the ________________ .
Answer(s): B
On a rear-wheel-drive vehicle, the driveshaft transmits power from the transmission to the differential. The flywheel is bolted directly to the crankshaft.
The order in which an engine's spark plugs fire is established by the order in which the .
Spark plug leads must be installed in the correct tower of the cap to ensure the proper firing order. The firing order is the order that the spark plugs ignite the air/fuel mixture in the combustion chamber. A typical firing order for a six-cylinder engine is 1-5-3-6-2-4.
The terminals exposed on the ignition induction coil are ________________.
On a conventional ignition coil, the center tower is the secondary or high-voltage terminal. The two small studs at the top of the coil are primary or low-voltage terminals.
Post your Comments and Discuss Test Prep ASVAB Section 7: General Science exam prep with other Community members:
Our website is free, but we have to fight against AI bots and content theft. We're sorry for the inconvenience caused by these security measures. You can access the rest of the ASVAB Section 7: General Science content, but please register or login to continue.