"Tracking," in terms of front-end alignment, means that __________.
Answer(s): D
Tracking is correct when both rear wheels are parallel to, and the same distance from, the vehicle centerline, which is an imaginary line drawn through the center of the vehicle. A bent frame or twisted body structure will cause improper tracking.
A car with worn-out shock absorbers __________.
Answer(s): B
Shock absorbers control spring oscillation. Original equipment shocks that do not use air or spring assists are not designed to control vehicle height.
In a three-speed transmission, the cluster gear is supported by the __________.
The countershaft is pressed into the transmission case and supports the cluster gear. The main shaft or output shaft is splined with the driveshaft.
A clutch release bearing __________.
Answer(s): C
When a clutch pedal is depressed, the release bearing comes in contact with the fingers of the clutch pressure plate and rotates.
The general procedure to follow when adjusting a band on an automatic transmission is to __________.
Answer(s): A
To properly adjust an automatic transmission band, loosen the adjusting screw locknut. Then tighten the adjusting screw to the specified torque with a torque wrench. Next, loosen the adjusting screw the specified number of turns. Complete the job by holding the adjusting screw and tightening the locknut.
Post your Comments and Discuss Test Prep ASVAB Test exam prep with other Community members: