QUESTION: 33

How does the Traceflow tool identify issues in a network?

Compares intended network state in the control plane with Tunnel End Point (TEP) keepalives in the data plane.
Compares the management plane configuration states containing control plane traffic and error reporting from transport node agents.
Injects ICMP traffic into the data plane and observes the results in the control plane.
Injects synthetic traffic into the data plane and observes the results in the control plane.

Answer(s): D

Explanation:

The Traceflow tool in NSX injects synthetic traffic into the data plane and monitors the traffic flow through the network, allowing administrators to observe how the traffic is handled at each hop. This approach helps identify issues such as dropped packets, routing errors, or misconfigurations by providing visibility into the path taken by the traffic and any potential disruptions.

Reveal Solution Next Question

QUESTION: 34

Where is the insertion point for East-West network introspection?

Tier-0 router
Guest VM vNIC
Partner SVM
Host Physical NIC

Answer(s): B

Explanation:

The insertion point for East-West network introspection in NSX is at the Guest VM vNIC (virtual Network Interface Card). By inspecting traffic at the vNIC level, NSX can monitor and apply security policies to traffic between virtual machines (East-West traffic) within the same network segment or data center, providing detailed security controls for VM-to-VM communication.

Reveal Solution Next Question

QUESTION: 35

Which is the only supported mode in NSX Global Manager when using Federation?

Proxy
Policy
Controller
Proton

Answer(s): B

Explanation:

When using NSX Federation, Policy mode is the only supported mode in NSX Global Manager. This mode allows centralized management and consistent policy enforcement across multiple NSX environments, providing a unified approach to managing network and security policies in federated deployments.

Reveal Solution Next Question

QUESTION: 36

When a stateful service is enabled for the first time on a Tier-0 Gateway, what happens on the NSX Edge node?

DR is instantiated and automatically connected with SR.
SR is instantiated and automatically connected with DR.
SR and DR doesn't need to be connected to provide any stateful services.
SR and DR is instantiated but requires manual connection.

Answer(s): B

Explanation:

When a stateful service (such as NAT or firewall) is enabled for the first time on a Tier-0 Gateway, the Service Router (SR) is instantiated on the NSX Edge node and automatically connected with the Distributed Router (DR). This connection enables the Tier-0 Gateway to handle stateful services by routing traffic through the SR, which manages stateful packet processing, while the DR provides distributed routing functionality.

Reveal Solution Next Question

Free 2V0-41.24 Exam Braindumps

QUESTION: 33

Explanation:

QUESTION: 34

Explanation:

QUESTION: 35

Explanation:

QUESTION: 36

Explanation: