QUESTION: 37

An NSX administrator is creating a Tier-1 Gateway configured in Active-Standby High Availability Mode. In the event of node failure, the failover policy should not allow the original failed node to become the Active node upon recovery.
Which failover policy meets this requirement?

Enable Preemptive
Non-Preemptive
Preemptive
Disable Preemptive

Answer(s): B

Explanation:

In Non-Preemptive failover policy, once a failover occurs and a new Active node is designated, the original failed node will not automatically become the Active node upon recovery. This setting ensures that the failover does not revert to the original node after it comes back online, maintaining the stability of the network by keeping the current Active node as is.

Reveal Solution Next Question

QUESTION: 38

Which CLI command is used for packet capture on the ESXi Node?

tcpdump
set capture
pktcap-uw
debug

Answer(s): C

Explanation:

The pktcap-uw command is specifically used on ESXi hosts for packet capture. It provides a detailed packet capture utility that allows administrators to capture traffic at various points on the ESXi host, such as virtual switches, uplinks, and VMkernel interfaces, making it a powerful tool for network troubleshooting on ESXi nodes.

Reveal Solution Next Question

QUESTION: 39

Which command on ESXi is used to verify the Local Control Plane connectivity with Central Control Plane?

esxcli network ip connection list | grep netcpa
esxcli network ip connection list | grep ccpd
esxcli network ip connection list | grep 1234
esxcli network ip connection list | grep 1235

Answer(s): A

Explanation:

The netcpa process is responsible for Local Control Plane (LCP) connectivity with the Central Control Plane (CCP) in NSX. Using the command esxcli network ip connection list | grep netcpa, administrators can verify the connectivity status between the LCP on the ESXi host and the CCP, ensuring proper communication for NSX operations.

Reveal Solution Next Question

QUESTION: 40

Which two statements describe the characteristics of an Edge Cluster in NSX? (Choose two.)

Must have only active-active edge nodes
Can contain multiple types of edge nodes (VM or bare metal)
Must contain only one type of edge nodes (VM or bare metal)
Can have a maximum of 10 edge nodes
Can have a maximum of 8 edge nodes

Answer(s): B,E

Explanation:

An NSX Edge Cluster can contain a mix of edge node types, meaning it can have both virtual machine (VM) and bare-metal edge nodes within the same cluster.

An NSX Edge Cluster supports a maximum of 8 edge nodes, allowing for scalability while adhering to the NSX design limitations for edge clusters.

Reveal Solution Next Question

Free 2V0-41.24 Exam Braindumps (page: 10)

QUESTION: 37

Explanation:

QUESTION: 38

Explanation:

QUESTION: 39

Explanation:

QUESTION: 40

Explanation: