Free 3V0-41.19 Exam Braindumps (page: 5)

Page 4 of 13

An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.
This information was gathered during a workshop:

- There are six hosts and hardware has already been purchased.
- Customer is planning a collapsed Management/Edge/Compute cluster.
- Each host has two 10Gb NICs connected to a pair of ToR switches.
- There should be no single point of failure in any proposed design.

Which virtual switch design should the architect recommend to the organization?

  1. Create an NSX-T Virtual Distributed Switch (N-VDS) for Management VMkernal and overlay traffic and assign a new virtual NIC.
  2. Create an NSX-T Virtual Distributed Switch (N-VDS) for Management VMkernel and overlay traffic and assign both NICs.
  3. Create an NSX-T Virtual Distributed Switch (N-VDS) for Management VMkernel traffic and assign one NI Also, create an NSX-T Virtual Distributed Switch (N-VDS) for overlay traffic and assign one NI
  4. Create a vSphere Distributed Switch (vDS) for Management VMkernel traffic and assign one NIC.
    Also, create an NSX-T Virtual Distributed Switch (N-VDS) for overlay traffic and assign one NIC.

Answer(s): A



An architect is helping an organization with the Physical Design of an NSX-T Data Center solution. This information was gathered during a workshop about ESXi Host networking:

- A total of 50 ESXI hosts to be configured as Transport Nodes.
- All ESXi hosts have a dedicated 2 x Intel 10Gbps Physical Network adapter for the Overlay Traffic. To achieve low latency, high throughput, redundancy, and performance, which two NIC teaming policies should the architect recommend? (Choose two.)

  1. Load Balance Port ID
  2. Load Balance Source
  3. Load Balance Source Port ID
  4. Fa Mover Order
  5. Load Balance Source MAC

Answer(s): A,C



A customer wants to place their NSX Managers in different subnets.
Which would an architect recommend to support the request?

  1. Use a cluster Virtual IP.
  2. Use round-robin DNS.
  3. Use a load balancer.
  4. Use NAT.

Answer(s): D



An architect is helping an organization with the Physical Design of an NSX-T Data Center solution. This information was gathered during the Assessment Phase:

- There Is a critical application used by the Finance Team.
- The critical application has an availability and recoverability SLA of 99.99%.
- The critical application Is sensitive to network changes.

Which two should an architect include in their design? (Choose two.)

  1. Install and configure hosts with 100Gbps physical NICs.
  2. Configure Tler-0 gateway for eBGP and ECMP.
  3. Configure Tier-1 gateway for eBGP and ECMP.
  4. Enable BFD on Tier-0 gateway.
  5. Configure multiple static routes on Tier-1 gateway.

Answer(s): B,D






Post your Comments and Discuss VMware 3V0-41.19 exam with other Community members:

3V0-41.19 Discussions & Posts