Free 3V0-42.20 Exam Braindumps (page: 3)

Page 3 of 15

An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution. This information was gathered by the architect during the Discover Task of the Enagagement Lifecycle:

-There are applications which use IPv6 addressing.
-Network administrators are not familiar with NSX-T Data Center solutions.
-Hosts can only be configured with two physical NICs.
-There is an existing management cluster to deploy the NSX-T components.
-Dynamic routing should be configured between the physical and virtual network.
-There is a storage array available to deploy NSX-T components.

Which constraint was documented by the architect? (Choose the best answer.)

  1. Dynamic routing should be configured between the physical and virtual network.
  2. There are applications which use IPv6 addressing.
  3. Hosts can only be configured with two physical NICs.
  4. There are enough CPU and memory resources in the existing management cluster.

Answer(s): A



Which two benefits can be achieved using in-band management of an NSX Bare Metal Edge Node? (Choose two.)

  1. Reduces storage requirements.
  2. Reduces cost.
  3. Preserves packet locality.
  4. Reduces egress data.
  5. Preserves switchports.

Answer(s): B,D



An architect is helping an organization with the Physical Design of an NSX-T Data Center solution. This information was gathered during a workshop:
-Any proposed solution must provide low latency.
-Any proposed solution must provide high throughput.
-Customer is running stock trading applications.

Which two selections should the architect recommend to meet high-performance workload requirements? (Choose two.)

  1. Leverage ESXi as the compute host.
  2. Use LACP for all uplink profiles.
  3. Leverage KVM as the compute host.
  4. Enable enhanced data path mode on the N-VDS.
  5. Enable latency sensitivity mode on the N-VDS.

Answer(s): A,D



Which selection is associated with the Review Task of the Engagement Lifecycle? (Choose the best answer.)

  1. Gather and document requirements, assumptions, and constraints.
  2. Build, deploy, implement, and test the design.
  3. Measure performance against customer’s objective.
  4. Create and document the logical and physical design.

Answer(s): C



Page 3 of 15



Post your Comments and Discuss VMware 3V0-42.20 exam with other Community members:

vp commented on November 14, 2023
C is the answer
Anonymous
upvote