support@Free-Braindumps.com
Register Login
Cisco
CompTIA
ISC
EC-Council
EXIN
Fortinet
ITIL
Juniper
Microsoft
VMware
Avaya
SAP
Google
NVIDIA
Salesforce
Amazon
Palo Alto Networks
ISC2
CrowdStrike
Anthropic
All Vendors
  1. Home
  2. Exams
  3. Cisco
  4. 200-301

Free 200-301 Exam Braindumps
Cisco Certified Network Associate (CCNA) Questions 381–385 (page: 78)

Updated On: 10-Feb-2026
Page 78 of 281
PDF with 1395 Questions

Which two statements about exterior routing protocols are true? (Choose two.)

  1. They determine the optimal within an autonomous system.
  2. They determine the optimal path between autonomous systems.
  3. BGP is the current standard exterior routing protocol.
  4. Most modern networking supports both EGP and BGP for external routing.
  5. Most modern network routers support both EGP and EIGRP for external routing.

Answer(s): B,C



You have two paths for the 10.10.10.0 network - one that has a feasible distance of 3072 and the other of 6144. What do you need to do to load balance your EIGRP routes?

  1. Change the maximum paths to 2
  2. Change the configuration so they both have the same feasible distance
  3. Change the variance for the path that has a feasible distance of 3072 to 2
  4. Change the IP addresses so both paths have the same source IP address

Answer(s): C



DRAG DROP (Drag and Drop is not supported)
Drag each route source from the left to the numbers on the right. Beginning with the lowest and ending with the highest administrative distance.
Select and Place:

  1. See Explanation section for answer.

Answer(s): A

Explanation:



Which two circumstances can prevent two routers from establishing an OSPF neighbor adjacency? (Choose two.)

  1. mismatched autonomous system numbers
  2. an ACL blocking traffic from multicast address 224.0.0.10
  3. mismatched process IDs
  4. mismatched hello timers and dead timers
  5. use of the same router ID on both devices

Answer(s): D,E



Which three describe the reasons large OSPF networks use a hierarchical design? (Choose three.)

  1. to speed up convergence
  2. to reduce routing overhead
  3. to lower costs by replacing routers with distribution layer switches
  4. to decrease latency by increasing bandwidth
  5. to confine network instability to single areas of the network
  6. to reduce the complexity of router configuration

Answer(s): A,B,E



  PDF
Viewing page 78 of 281
Viewing questions 386 - 390 out of 1395 questions


Post your Comments and Discuss Cisco 200-301 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!