Free 300-410 Exam Braindumps
Implementing Cisco Enterprise Advanced Routing and Services (ENARSI) Questions 121–128 (page: 17)

Updated On: 9-Jul-2026

Which OSI model is used to insert an MPLS label?

  1. between Layer 2 and Layer 3
  2. between Layer 5 and Layer 6
  3. between Layer 1 and Layer 2
  4. between Layer 3 and Layer 4

Answer(s): A



Which function does LDP provide in an MPLS topology?

  1. It enables a MPLS topology to connect multiple VPNs to P routers.
  2. It provides hop-by-hop forwarding in an MPLS topology for LSRs.
  3. It exchanges routes for MPLS VPNs across different VRFs.
  4. It provides a means for LSRs to exchange IP routes.

Answer(s): B



Which mechanism provides traffic segmentation within a DMVPN network?

  1. BGP
  2. IPsec
  3. MPLS
  4. RSVP

Answer(s): C



Refer to the exhibit. Which configuration denies Telnet traffic to router 2 from 198A:0:200C::1/64?





Answer(s): A



Refer to the exhibit. During troubleshooting it was discovered that the device is not reachable using a secure web browser. What is needed to fix the problem?

  1. permit tcp port 443
  2. permit udp port 465
  3. permit tcp port 465
  4. permit tcp port 22

Answer(s): A



DRAG DROP (Drag and Drop is not supported)
Drag and drop the packet types from the left onto the correct descriptions on the right.
Select and Place:

  1. See Explanation section for answer.

Answer(s): A

Explanation:



DRAG DROP (Drag and Drop is not supported)
Drag and drop the addresses from the left onto the correct IPv6 filter purposes on the right.
Select and Place:

  1. See Explanation section for answer.

Answer(s): A

Explanation:



Refer to the exhibit. An engineer is trying to configure local authentication on the console line, but the device is trying to authenticate using TACACS+. Which action produces the desired configuration?

  1. Add the aaa authentication login default none command to the global configuration.
  2. Replace the capital “C” with a lowercase “c” in the aaa authentication login Console local command.
  3. Add the aaa authentication login default group tacacs+ local-case command to the global configuration.
  4. Add the login authentication Console command to the line configuration

Answer(s): D



Viewing page 17 of 81
Viewing questions 129 - 136 out of 640 questions


Post your Comments and Discuss Cisco 300-410 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!