CompTIA
Checkpoint
ISC
HP
Dell
EC-Council
EXIN
Fortinet
ITIL®
Juniper
PMI
Microsoft
VMware
Avaya
Google
Salesforce
Amazon
Palo Alto Networks
Certiport
ISC2
All Vendors
  2. Home
  3. Exams
  4. Cisco®
  5. 300-615

Free 300-615 Exam Braindumps (page: 2)

Page 1 of 63
PDF with 247 Questions

A vPC Type-1 inconsistency between two vPC peers in a VXLAN EVPN setup is discovered. Which two actions need to be attempted to resolve the issue? (Choose two.)

  1. Configure the NVE interfaces to be Up on both switches.
  2. Set a different distributed gateway virtual MAC address.
  3. Set a different secondary IP addresses on NVE source-interface.
  4. Configure the same VNI to multicast group maping.
  5. Set a different primary IP addresses on NVE source-interface.

Answer(s): A,D



A mission-critical server is connected to siteA. Connectivity to this server is lost from site B because the MACroute is missing in the OTV VDC of the Cisco Nexus 7000 in site B due to MAC aging. Which action allows theflooding of the unknown unicast MAC on the Nexus 7000 in the OTV VDC?

  1. Use route map to statically advertise this MAC and redistribute with IS-IS.
  2. Unknown unicast flooding is not allowed.
  3. Use the otv flood mac <> command to selectively flood traffic for a given MA
  4. Use the otvisisbfd<> command to configure BFD protocol.

Answer(s): B



Refer to the exhibit. After a failover occurs, which two actions must be performed on Switch-B to manuallypreempt the operational primary role back to Switch-A? (Choose two.)

  1. Configure the local vPC role priority to have a lower value than Switch-
  2. Configure the local vPC role priority to have a higher value than Switch-A.
  3. Disable and then re-enable the vPC peer-keepalive link.
  4. Configure the local vPC role priority to have the same value as Switch-A.
  5. Disable and then re-enable the vPC peer link.

Answer(s): B,E



Refer to the exhibit. An OSPF adjacency between Router-A and Router-B fails to reach the FULL state. Which action resolves the issue?

  1. Adjust the MTU on Router-A to 1600.
  2. Disable the check of the MTU value.
  3. Set the OSPF media type to point-to-point.
  4. Adjust the MTU on Router-B to 1604.

Answer(s): B






Post your Comments and Discuss Cisco® 300-615 exam with other Community members:

300-615 Discussions & Posts