Cisco 300-615 Exam Questions
Troubleshooting Cisco Data Center Infrastructure (DCIT) (Page 10 )

Refer to the exhibit.



The VXLAN fabric with BGP EVPN control plane experiences connectivity issues. The hosts in the initial deployed VLAN fail to communicate. The environment is configured as follows:
Private BGP ASN 65122 is used across the whole fabric.
Each leaf node has iBGP peers with each spine node with default values.
Address family L2VPN EVPN is enabled on all leaf and spine BGP speakers.

Which BGP feature is required on the spines for all EVPN routes to be advertised throughout the VXLAN fabric?

Refer to the exhibit.



A port channel on a Cisco Nexus 9000 Series Switch uplink experiences connectivity issues. Which configuration resolves the issue?

Refer to the exhibit.



An engineer must restore the connectivity issue between NEXUS-SW-3 and NEXUS-SW-4. The engineer can ping the physical and loopback interfaces used in the underlay from VTEP-1. However, communication between the SVIs in NEXUS-SW-3 and NEXUS-SW-4 fails. Which action resolves the issue?

Refer to the exhibit.



A Cisco VXLAN must use bidirectional PIM so that:

•Spine2 is the active RP for multicast group 225.0.0.0/24.
•Loopback 254 is used as a logical interface for PIM configuration.

After configuration was applied, Spine1 became the active RP for multicast group 225.0.0.0/24 instead of Spine2. Which action resolves the issue?

Refer to the exhibit.



An engineer configures EVPN on Switch-1. but the neighbors fail to exchange EVPN routes. Which action resolves the issue?