Cisco
CompTIA
ISC
EC-Council
EXIN
Fortinet
ITIL
Juniper
Microsoft
VMware
Avaya
SAP
Google
NVIDIA
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk
ServiceNow
All Vendors
  2. Home
  3. Exams
  4. Cisco
  5. 350-401

Cisco 350-401 Exam Questions
Implementing Cisco Enterprise Network Core Technologies (ENCOR) (Page 51 )

Updated On: 10-Mar-2026
Page 38 of 193
PDF with 1067 Questions

Refer to the exhibit. The trunk between Gig1/0/1 of switch SW2 and Gig1/0/1 of switch SW1 is not operational. Which action resolves this issue?

  1. Configure both interfaces to nonegotiate and ensure that the switches are in different VTP domains.
  2. Configure both interfaces in dynamic auto DTP mode and ensure that the switches are in the same VTP domain.
  3. Configure both interfaces in dynamic auto DTP mode and ensure that the switches are in different VTP domains.
  4. Configure both interfaces in dynamic desirable DTP mode and ensure that the switches are in the same VTP domain.

Answer(s): D



Refer to the exhibit. Which two facts does the device output confirm? (Choose two.)

  1. The device's HSRP group uses the virtual IP address 10.0.3.242.
  2. The device is configured with the default HSRP priority.
  3. The device sends unicast messages to its peers.
  4. The standby device is configured with the default HSRP priority.
  5. The device is using the default HSRP hello timer.

Answer(s): D,E



Refer to the exhibit. Which type of antenna is shown on the radiation patterns?

  1. patch
  2. dipole
  3. omnidirectional
  4. Yagi

Answer(s): B



DRAG DROP (Drag and Drop is not supported)
Drag and drop the descriptions from the left onto the routing protocol they describe on the right.
Select and Place:

  1. See Explanation section for answer.

Answer(s): A

Explanation:



Refer to the exhibit. All switches are configured with the default port priority value. Which two commands ensure that traffic from PC1 is forwarded over the Gi1/3 trunk port between DSW1 and DSW2? (Choose two.)

  1. DSW2(config)#interface gi1/3
  2. DSW1(config-if)#spanning-tree port-priority 0
  3. DSW2(config-if)#spanning-tree port-priority 128
  4. DSW1(config)#interface gi1/3
  5. DSW2(config-if)#spanning-tree port-priority 16

Answer(s): A,E

Explanation:

Priority is chosen based on the upstream port, therefore we need to make this change on DSW2. This means answers B and D are out.

Port priority is set in increments of 16:

Switch(config-if)#spanning-tree port-priority ?
<0-240> port priority in increments of 16

This leaves us with C or E. C is the default, so won't change the behaviour here, so it's out too.
The only two still standing are A & E.



Viewing page 51 of 193
Viewing questions 251 - 255 out of 1067 questions



Post your Comments and Discuss Cisco 350-401 exam dumps with other Community members:

350-401 Exam Discussions & Posts

AI Tutor