Free 350-401 Exam Braindumps
Implementing Cisco Enterprise Network Core Technologies (ENCOR) Questions 251–255 (page: 52)

Updated On: 10-Feb-2026

Which command set configures RSPAN to capture outgoing traffic from VLAN 3 on interface GigabitEthernet 0/3 while ignoring other VLAN traffic on the same interface?

  1. monitor session 2 source interface gigabitethernet0/3 rx monitor session 2 filter vlan 3
  2. monitor session 2 source interface gigabitethernet0/3 rx monitor session 2 filter vlan 1 - 2, 4 - 4094
  3. monitor session 2 source interface gigabitethernet0/3 tx monitor session 2 filter vlan 3
  4. monitor session 2 source interface gigabitethernet0/3 tx monitor session 2 filter vlan 1- 2, 4 - 4094

Answer(s): C



Refer to the exhibit.



What is required to configure a second export destination for IP address 192.168.10.1?

  1. Specify a different UDP port.
  2. Specify a different TCP port.
  3. Configure a version 5 flow-export to the same destination.
  4. Specify a different flow I
  5. Specify a VRF.

Answer(s): A



Refer to the exhibit.


After implementing the configuration, 172.20.20.2 stops replying to ICMP echos, but the default route fails to be removed. What is the reason for this behaviour?

  1. The threshold value is wrong.
  2. The source-interface is configured incorrectly.
  3. The destination must be 172.30.30.2 for icmp-echo.
  4. The default route is missing the track feature.

Answer(s): D



Refer to the exhibit.


An engineer is troubleshooting a connectivity issue and executes a traceroute. What does the result confirm?

  1. The destination port is unreachable.
  2. The probe timed out.
  3. The destination server reported it is too busy.
  4. The protocol is unreachable.

Answer(s): B

Explanation:

In Cisco routers, the codes for a traceroute command reply are:
! " success
* " time out
N " network unreachable -
H " host unreachable -
P " protocol unreachable -
A " admin denied -
Q " source quench received (congestion)
? " unknown (any other ICMP message). In Cisco routers, the codes for a traceroute command reply are:
! " success
* " time out
N " network unreachable -
H " host unreachable -
P " protocol unreachable -
A " admin denied -
Q " source quench received (congestion)
? " unknown (any other ICMP message)



Which Cisco DNA Center application is responsible for group-based access control permissions?

  1. Provision
  2. Design
  3. Assurance
  4. Policy

Answer(s): D


Reference:

https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-and-management/dna-center/1-3-1-0/user_guide/b_cisco_dna_center_ug_1_3_1_0/b_cisco_dna_center_ug_1_3_1_0_chapter_01011.html



Viewing page 52 of 193
Viewing questions 256 - 260 out of 1067 questions


Post your Comments and Discuss Cisco 350-401 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!