Free 350-501 Exam Braindumps (page: 24)

Page 23 of 100

Refer to the exhibit. A network operator needs to shut down interface Gi0/0/0/2 for maintenance. What occurs to the interface states of Gi0/0/0/0 and Gi0/0/0/1?

  1. Gi0/0/0/1 and Gi0/0/0/0 become active
  2. Gi0/0/0/1 and Gi0/0/0/0 remain standby
  3. Gi0/0/0/0 becomes active; Gi0/0/0/1 remains standby
  4. Gi0/0/0/1 becomes active; Gi0/0/0/0 remains standby

Answer(s): D



Refer to the exhibit. When the Link Aggregation configuration router is running on Cisco IOS XR Software, which LACP interface configuration is needed to add the interface to the bundle?





Answer(s): B



A network engineer must enable the helper router to terminate the OSPF graceful restart process if it detects any changes in the LSA. Which command enables this feature?

  1. nsf ietf helper disable
  2. nsf cisco helper disable
  3. nsf ietf helper strict-lsa-checking
  4. nsf cisco enforce global

Answer(s): C



Refer to the exhibit. A network engineer is implementing an OSPF configuration. Based on the output, which statement is true?

  1. OSPFv3 does not run for IPv4 on FastEthernet0/0 until IPv6 routing is enabled on the router and IPv6 is enabled on interface FastEthernet0/0.
  2. In the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.
  3. OSPFv3 cannot be configured for IPv4; OSPFv3 works only for IPv6.
  4. “IPv6 routing not enabled” is just an informational message and OSPFv3 runs for IPv4 on interface FastEthernet0/0 anyway.

Answer(s): A






Post your Comments and Discuss Cisco® 350-501 exam with other Community members:

350-501 Discussions & Posts