A storage array must be connected to port ethernet1/10 on a Cisco MDS 9000 Series Switch. In addition, the array must connect using the FCoE protocol and be single-homed. Which configuration meets these requirements?
Answer(s): B
We must use mode f, because in a switch, on a port which connects to a node, we configure an F port (fabric port). On the endhost (array/storage) side, this port is an N (node) port.
What is the impact of an EPLD upgrade on a Cisco MDS 9000 Series Switch?
Answer(s): C
When you upgrade or downgrade the EPLDs, observe the following guidelines and limitations:* You can upgrade each module only when it is online. The EPLD upgrade is only disruptive to the module being upgraded.* If you interrupt an EPLD upgrade or downgrade, the module must be upgraded again.* In Cisco MDS 9000 Director Switches, EPLD upgrade or downgrade can only be executed from the active supervisor module. To upgrade the supervisorEPLDs nondisruptively, upgrade the standby supervisor and then switchover. After the new standby supervisor is online its EPLDs can be upgraded.* In Cisco MDS 9000 Series Fabric Switches, be sure to specify 1 as the module number. The switch must be power cycled for the EPLDs to start running the new code.
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/mds9000/sw/8_x/release_notes/epld/epld_rn_8x.html
An engineer must implement the FCoE on the Cisco Nexus 9000 Series Switch-based infrastructure. The deployment will contain dual-homed fabric extenders and must support jumbo frames with port channels. Which two sets of actions complete the configuration? (Choose two.)
Answer(s): A,D
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/92x/fcoe/configuration/guide/b-cisco-nexus-9000-nx-os-fcoe-configuration- guide-92x/b-cisco-nexus-9000-nx-os-fcoe-configuration-guide-92x_chapter_0100.pdf
Refer to the exhibit. A network engineer must configure port E1/31-32 to forward only storage server traffic of VLAN 200 on Cisco fabric interconnects A and B.Port E1/31-32 is not reserved for any other traffic. Which port type must be configured to accomplish this goal?
Answer(s): D
FCoE uplink ports are physical Ethernet interfaces between the fabric interconnects and the upstream Ethernet switch, used for carrying FCoE traffic. E1/31-32 is the link between the 2 switches and between switch and FI.
What is an advantage of NFS as compared to Fibre Channel?
When we create VMs on the NFS-LUN, the wizard only lets you choose for Thin Provisioning, which is normal and good since we only use the datastore for templates.
https://communities.vmware.com/t5/ESXi-Discussions/NFS-Thin-Provisioning-becomes-thick-after-creation/td-p/1296112
Post your Comments and Discuss Cisco 350-601 exam prep with other Community members:
Our website is free, but we have to fight against AI bots and content theft. We're sorry for the inconvenience caused by these security measures. You can access the rest of the 350-601 content, but please register or login to continue.