QUESTION: 17

From an application perspective what should be done prior to performing an SRDF Fallback operation?

Continue accessing the R2 devices
Start accessing the R1 devices before running the command
Stop accessing the R2 devices
Run the command and then start accessing the R1 devices
Stop accessing the R2 devices
Start accessing the R1 devices before running the command
Continue accessing the R2 devices
Run the command and then start accessing the R1 devices

Answer(s): B

A VMAX3 array has been configured with two Storage Resource Pools (SRP) Source volumes are assigned to SRP_1 and target volumes are assigned to SRP_2. A TimeFinder SnapVX snapshot of the source volumes is linked to the target volumes in the default mode

What will happen when there are new host writes to the source volumes?

Snapshot deltas will be stored in the Reserved Capacity of SRP_1
Snapshot deltas will be stored in SRP__2
Snapshot deltas will be stored in the Reserved Capacity of SRP_2
Snapshot deltas will be stored in SRP_1

Answer(s): D

Reveal Solution Next Question

QUESTION: 19

A PowerMax administrator is provisioning their environment using Solutions Enabler 9.0 and Unisphere for PowerMax Two large Storage Resource Pools (SRPs) have been configured for virtual provisioning. The pools are setup with RAID 5 (7+1) TDATs and there are no errors

The administrator is able to fully access and browse each pool's elements and decided to make some modifications to the pools However, they are unable to edit or make any changes to the pool attributes What is the most likely reason for this issue?