QUESTION: 25

A system administrator has added a new Unity storage array to their environment. The administrator wants to migrate block data from vVNX running in their VMware environment to a UnityVSA. In addition, the administrator needs to migrate the block data from an older CLARiiON storage array to the new Unity storage array.

Which single block migration option will work for both the virtual and hardware storage devices?

SAN Copy Push
VPLEX
Host-Based LVM
RecoverPoint

Answer(s): A

Explanation:

You move Block storage from a CLARiiON CX or VNX Series storage system to an EMC Unity system.

Note: Clariion (styled CLARiiON) is a discontinued [1] SAN disk array manufactured and sold by EMC Corporation, it occupied the entry-level and mid-range of EMC's SAN disk array products. In 2011, EMC introduced the EMC VNX Series, designed to replace both the Clariion and Celerra products.

Incorrect Answers:
D: EMC RecoverPoint protects storage arrays LUNs and provides concurrent local and multiple remote data replication copies with continuous data protection for any PiT Recovery. It supports EMC VMAX 10K, 20K, 40K, VNX, VNXe3200, VNX-F, VPLEX, XtremIO and 3rd party arrays via VPLEX.

Reveal Solution Next Question

QUESTION: 26

How is encryption set for a Unity storage system?

Clicking the “Mode” checkbox on the Manage Encryption page
Selecting “Status” on the Manage Encryption page
Automatically set at the factory
First time the license is applied

Answer(s): D

Explanation:

D@RE is included by default on Unity arrays and included in the Unity license file unless otherwise requested during ordering. Therefore, all that is needed to activate D@RE is to install the D@RE enabled license file. The license installation process is not specific to D@RE, and is required to be performed before using the array.
When logging into Unisphere for the first time, license installation appears as a step of the Unisphere Configuration Wizard, prompting the administrator to install the license file obtained from EMC. If this license file includes D@RE functionality, D@RE will be enabled once the license file is installed successfully

Note: Unity storage systems address sensitive data concerns through controller-based Data at Rest Encryption (D@RE), which encrypts stored data as it is written to disk.
D@RE is a license controlled feature available by default on Unity storage systems, and, being designed to be largely invisible to administrative end users, requires almost no effort to enable or manage. Enabling the feature or backing up the encryption keys externally takes just seconds, and redundant keystore backups stored on array ensure that user data is always as available as it is secure.

Reveal Solution Next Question

QUESTION: 27

A system administrator experienced a power failure in their environment. To which device will cache de-stage?

M.2 SSD on each Storage Processor
First four disks in the Disk Processor Enclosure
Cache does not need to de-stage as it is now non-volatile
Backup Battery Unit will keep the data alive in cache

Answer(s): A

Reveal Solution Next Question

QUESTION: 28

A service provider is installing a Unity storage system for an end-user. The end-user is concerned about network security and will not allow the service provider access to the network.
How can the service provider set a static IP address for the Unity storage system management interface?

Use the embedded InitCLI tool
Connect directly to the service ports and configure the networking through UEMCLI
Use an IPMI serial over LAN connection
Use the Connection Utility to create a configuration file

Answer(s): B

Explanation:

The svc_initial_config UEMCLI command sets up initial system configuration. It configures a management IP address when the Connection Utility (CU) is not available on the network. If an address is set, this command can also change the management IPv4 and IPv6 configuration mode. It attempts to configure the system with the given friendly name and/or network parameters.

Note: The Unisphere CLI (UEMCLI) is a tool that provides us with the CLI access to perform the same actions as one would on the Unisphere web interface.

Reference:

https://www.emc.com/collateral/TechnicalDocument/docu69328.pdf (page 60)

Reveal Solution Next Question

Free E20-393 Exam Braindumps (page: 7)

QUESTION: 25

Explanation:

QUESTION: 26

Explanation:

QUESTION: 27

QUESTION: 28

Explanation:

Reference: