Free H12-811 Exam Braindumps
HCIA-Datacom V1.0 Questions 608–612 (page: 73)

Updated On: 31-Jan-2026

On Huawei ARG3 series routers, what authentication modes does AA

  1. support? () 802.1x
  2. Local
  3. None
  4. HWTACACS

Answer(s): B,C,D



The output information of a certain device is shown in the figure. Which of the following statements is correct? ( )

display interface G1gabitEthernet 0/0/0 G1 gabi tEthernet0/0/0 currentstate UP Line protocol current state UP Route Port,The Maximum Transmit Unit is 1000 Internet Address is 10.0.12.2/24 IP Sending Frames'Format is PRTFMT ETENT 2.Hardware address is 00e0-fc22-4fff Port Mode:FORCE COPPER SpeeD.:100, Loopback:NONE Duplex:FULL, Negotiation:DISABLE Md1 AUTO Last 300 seconds input rate 24 bits/seC.0 packets/sec Last 300 seconds output rate 24 bits /seC.0 packets/seC.*

  1. The P address of the interface is 10.0.12.2/24
  2. The MAC of the interface. The address is 00e0-fc22-4fff
  3. The working rate of this interface is 1Gbps
  4. The MTU value of this interface is 1000

Answer(s): A,B,D



Which of the following commands can be used to query the configuration information of the device's 0SPF protocol? ()*


  1. dis ip routing-table

  2. Enter the command "display t in the OsPF protocol view.
    his\
    ,.:

    ,.:

Answer(s): A,B



The transmission rate of the Eth-Truk port in manual link aggregation mode is related to ().*

  1. Number of member ports
  2. Bandwidth of member port
  3. Whether an IP address is configured on the member port
  4. Is the member port on the public or private network

Answer(s): A,B



In order to realize the network layer function on the VLANIF interface, do you need to configure it on the VLANIF interface? ()

  1. MAC.Address
  2. Subnet mask
  3. IP prefix
  4. IP address

Answer(s): B,D



Viewing page 73 of 147
Viewing questions 361 - 365 out of 872 questions


Post your Comments and Discuss Huawei H12-811 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!