4A0-C01 Practice Test & Exam Dumps
Nokia NRS II Composite Exam Questions 361–365 (page: 74)

Updated On: 9-Feb-2026

Why does IPv6 not use ARP?

  1. The ARP functionality has been replaced by the Neighbor Discovery protocol.
  2. The ARP functionality is not needed due to the increased IPv6 address space.
  3. ICMPv6 reduced its role to connectivity checking and auto-configuration only.
  4. ICMFV6 replaced the ARP functionality with Multicast Listener Discovery (MLD).

Answer(s): A



Which of the following statements best defines an LSP?

  1. An LSP is a bidirectional path across the MPLS domain.
  2. An LSP is a bidirectional path for a particular FEC across the MPLS domain.
  3. An LSP is a unidirectional path across the MPLS domain.
  4. An LSP is a bidirectional path between adjacent LSRs.
  5. An LSP is a unidirectional path between adjacent LSRs.

Answer(s): C



An LSP path is configured as follows:
- Shared-explicit reservation style
- Make-before-break (MBB) enabled
- 500Mpbs bandwidth reserved on a 1Gbps link
With 100Mbps of unreserved bandwidth remaining, the operator increases the LSP-path's bandwidth reservation to 900Mbps. What happens to the existing LSP?

  1. CSPF looks for the delta bandwidth, taking down the first path if necessary.
  2. CSPF looks for the delta bandwidth, implementing make-before-break.
  3. After 5 failed attempts to find the bandwidth requested, the head end disables the LSP.
  4. CSPF looks for the entire bandwidth requested, implementing MBB.

Answer(s): B



Which of the following LDP messages are used in the successful establishment of LDP sessions? Choose three answers

  1. Label request message
  2. Notification message
  3. Address message
  4. Keepalive message
  5. Initialization message
  6. Hello message

Answer(s): D,E,F



Click on the exhibit button below. Assume the following:

- Each router's OSPF interfaces are in the areas shown.
- Bidirectional LDP-over-RSVP tunnels extend from routers R1 to R3 and back over the path R1-R4-R5-R3.
- You enable fast reroute facility bypass on the R5-R3 RSVP LSP.
- Router R5 acts as a PLR, protecting the R5-R3 link by building a bypass tunnel through router R2. You build a layer 2 VPN on routers R1 and R3, using the LDP-over-RSVP tunnels. What MPLS configuration step must you complete on router R2 for it to protect the end-to-end service?

  1. Enable LDP on the R2-R5 interface.
  2. Configure T-LDP sessions between routers R2 and R5 and R3.
  3. Configure LDP-over-RSVP support on router R2.
  4. Enable MPLS and RSVP on the router R2 network interfaces.
  5. Enable LDP on the R2-R5 and R2-R3 interfaces.

Answer(s): D



Viewing page 74 of 170
Viewing questions 366 - 370 out of 852 questions


Post your Comments and Discuss Nokia 4A0-C01 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!