QUESTION: 185

In a new physical in-path deployment, you realize that a Steelhead appliance at one of your branch offices is optimizing connections from other sites, however, no connections initiated from that branch office are being optimized. Which of the following is the most likely cause of this problem?

Duplex mismatch
Bilateral Opportunistic Lock failure
Policy-based routing incorrectly configured
Reversed WAN and LAN cabling

Answer(s): D

Reveal Solution Next Question

QUESTION: 186

When troubleshooting a datastore wrapping alarm with 1 day wrapping notification configured, which of the following should be examined? (Select 2)

If the unit was mis-sized
If stream based encrypted traffic is being sent across the link as optimized
If your fixed-target rules are pointing to the correct Steelhead appliance
If Connection Forwarding was properly configured

Answer(s): A,B

Reveal Solution Next Question

QUESTION: 187

What should you do when you receive the following message?

Nothing. This is a warning message which means that the Steelhead appliance is resetting an internal state regarding this connection and it should not affect user performance.
Switch off the Steelhead appliance
Create a specific pass-through rule to bypass the above source and destination hosts
Reload the Steelhead appliance

Answer(s): A

Reveal Solution Next Question

QUESTION: 188

What should you do when you receive the following message? [intercept.NOTICE] sending kickoff RST: 10.35.178.41:1169 -> 10.110.141.30:1031.

Nothing. This is just a notice message.
Verify whether the "Reset Existing Client Connections on Start Up" option is checked and uncheck it
Switch off the Steelhead appliance
Create a specific pass-through rule to bypass the above source and destination hosts
Restart the Steelhead appliance

Answer(s): B

Reveal Solution Next Question

Free 830-01 Exam Braindumps (page: 48)

QUESTION: 185

QUESTION: 186

QUESTION: 187

QUESTION: 188

830-01 Discussions & Posts