Free 200-301 Exam Braindumps (page: 34)

Page 33 of 350

Refer to the exhibit. The router has been configured with a super net to accommodate the requirements for 380 users on a Subnet. The requirement already considers 30% future growth. Which configuration verifies the IP subnet on router R4?

  1. Subnet: 10.7.54.0 Subnet mask: 255.255.128.0 Broadcast address: 10.5.55.255 Usable IP address range: 10.7.54.1 “" 10.7.55.254
  2. Subnet: 10.7.54.0 Subnet mask: 255.255.255.0 Broadcast address: 10.7.54.255 Usable IP address range: 10.7.54.1 “" 10.7.55.254
  3. Subnet: 10.7.54.0 Subnet mask: 255.255.254.0 Broadcast address: 10.7.54.255 Usable IP address range: 10.7.54.1 “" 10.7.55.254
  4. Subnet: 10.7.54.0 Subnet mask: 255.255.254.0 Broadcast address: 10.7.55.255 Usable IP address range: 10.7.54.1 “" 10.7.55.254

Answer(s): D



Refer to the exhibit. Configurations for the switch and PCs are complete. Which configuration must be applied so that VLANs 2 and 3 communicate back and forth?

  1. interface GigabitEthernet0/0 ip address 10.10.2.10 255.255.252.0
  2. interface GigabitEthernet0/0.10 encapsulation dot1Q 3 ip address 10.10.2.10 255.255.254.0
  3. interface GigabitEthernet0/0.3 encapsulation dot1Q 3 native ip address 10.10.2.10 255.255.252.0
  4. interface GigabitEthernet0/0.3 encapsulation dot1Q 10 ip address 10.10.2.10 255.255.255.252

Answer(s): B



DRAG DROP (Drag and Drop is not supported)
Drag and drop the IPv6 address type characteristics from the left to the right.
Select and Place:

  1. See Explanation section for answer.

Answer(s): A

Explanation:



DRAG DROP (Drag and Drop is not supported)
Refer to the exhibit. The IP address configurations must be completed on the DC-1 and HQ-1 routers based on these requirements:


-DC-1 Gi1/0 must be the last usable address on a /30
-DC-1 Gi1/1 must be the first usable address on a /29
-DC-1 Gi1/2 must be the last usable address on a /28
-HQ-1 Gi1/3 must be the last usable address on a /29

Drag and drop the commands from the left onto the destination interfaces on the right. Not all commands are used.
Select and Place:

  1. See Explanation section for answer.

Answer(s): A

Explanation:






Post your Comments and Discuss Cisco® 200-301 exam with other Community members:

200-301 Discussions & Posts