Free 350-601 Exam Braindumps (page: 32)

Page 31 of 125

Refer to the exhibit.


Which type of backup is required to restore a Cisco UCS configuration?

  1. system configuration
  2. all configuration
  3. full state
  4. logical configuration

Answer(s): C


Reference:

https://www.cisco.com/en/US/docs/unified_computing/ucs/sw/gui/config/guide/141/UCSM_GUI_Configuration_Guide_141_chapter43.html



Which server policy is used to install new Cisco IMC software on a server?

  1. hypervisor firmware policy
  2. host firmware policy
  3. BIOS software policy
  4. Cisco IMC software policy

Answer(s): D



What are two requirements when planning a Cisco HyperFlex All Flash standard cluster installation using three Cisco HX240c M5 Series servers? (Choose two.)

  1. If the Jumbo MTU option in the HyperFlex installer is enabled, then jumbo frames do not have to be enabled on the upstream switches.
  2. This cluster deployment type must support a mix of HDD and SSD.
  3. The servers must be discovered, unassociated, and connected to each fabric interconnect.
  4. If the Jumbo MTU option in the HyperFlex installer is enabled, then jumbo frames must also be enabled on the upstream switches.
  5. The hypervisors must be installed to Cisco FlexFlash SD cards.

Answer(s): C,D


Reference:

https://www.cisco.com/c/en/us/td/docs/hyperconverged_systems/HyperFlex_HX_DataPlatformSoftware/AdminGuide/3_5/b_HyperFlexSystems_AdministrationGuide_3_5/b_HyperFlexSystems_AdministrationGuide_3_5_chapter_01111.html



Refer to the exhibit.



Service degradation is reported on a VM that is deployed on a Cisco UCS B-Series Server. The traffic from the vNIC is required to SPAN in both directions to a packet analyzer that is connected to UCS-A slot 2 port 12. Which two commands are needed to complete the configuration? (Choose two.)

  1. UCS-A /org/service-profile/vnic/mon-src* # set direction receive transmit
  2. UCS-A /eth-traffic-mon/fabric/eth-mon-session* # create dest-interface 2 12
  3. UCS-A /eth-traffic-mon/fabric/eth-mon-session # activate
  4. UCS-A /eth-traffic-mon/fabric/eth-mon-session* # create eth-mon-session/dest-interface 2 12
  5. UCS-A /org/service-profile/vnic/mon-src* # set direction both

Answer(s): B,E


Reference:

https://www.cisco.com/en/US/docs/unified_computing/ucs/sw/cli/config/guide/1.4.1/CLI_Config_Guide_1_4_1_chapter42.html






Post your Comments and Discuss Cisco® 350-601 exam with other Community members:

350-601 Discussions & Posts